ISO/TS TECHNICAL SPECIFICATION 19708 First edition 2007-03-15 Geosynthetics Procedure for simulating damage under interlocking concrete-block pavement by the roller compactor method Géosynthétiques Mode operatoire pour simuler I'endommagement sous un revetement en paves béton autobloquants par la méthode du compacteurarouleau Reference number ISO/TS 19708:2007(E) @ ISO 2007 by IHS under lic ted without license from IHS Not for Resale ISO/TS 19708:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007-All rights reserved ermittedwithoutlicense from IHS Not for Resale ISO/TS 19708:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In other circumstances, particularly when there is an urgent market requirement for such documents, : technical committee may decide to publish other types of normative document: an IsO working group and is accepted for publication if it is approved by more than 50 % of the members of the parent committee casting a vote; a vote. An ISO/PAS or ISO/TS is reviewed after three years in order to decide whether it will be confirmed for a further three years, revised to become an International Standard, or withdrawn. If the ISO/PAS or ISO/TS is confirmed, it is reviewed again after a further three years, at which time it must either be transformed into an International Standard or be withdrawn. Attentionisdrawntothepossibilitythatsomeoftheelementsofthisdocumentmaybethesubjectofpatent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO/TS 19708 was prepared by Technical Committee ISO/TC 221, Geosynthetics. ili Not for Resale neworkingmitedwithout licenefrmH No reproductic Not for Resale TECHNICAL SPECIFICATION ISO/TS 19708:2007(E) Geosynthetics Procedure for simulating damage under interlocking-concrete-block pavement by the roller compactor method Scope This Technical Specification specifies a test method for the determination, using a roller compactor for bituminous mixtures, of the damage to a geosynthetic used as a separator in interlocking-concrete-block pavements.Thegeosyntheticisplacedbetweenacushion-sand course andabasecoarsematerial.The roller compactor simulates highway traffic load and pedestrian load. After the roller compactor test, the cushion sand retained is determined. This Technical Specification can be used for selecting a geosynthetic. 2 Normative