ISO/TR TECHNICAL REPORT 16880 First edition 2004-04-01 Cranes Bridge and gantry cranes International Standards for design and manufacturing requirements and recommendations Appareils de levage a charge suspendue - Ponts roulants et ponts portiques Normes Internationales sur les exigences de conception et defabrication Reference number ISO/TR 16880:2004(E) ISO Copyright International Organization for Standardization @ISO2004 Not for Resale ISO/TR16880:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2004-All rights reserved mittedwithoutlicense from IHS Not for Resale ISO/TR 16880:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely ywiththe International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In exceptional circumstances, when a technical committee has collected data of a different kind from that informative in nature and does not have to be reviewed until the data it provides are considered to be no longer valid or useful. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO/TR 16880 was prepared by Technical Committee ISO/TC 96, Cranes, Subcommittee SC 9, Bridge and gantrycranes. ili CopyightIntematinal Oranization for Standardizalon'ghts reserved yhemainaanaioSandardizato orneworkingmitedwithout licene fromH Not for Resale TECHNICAL REPORT ISO/TR 16880:2004(E) Cranes Bridge and gantry cranes International Standards for design and manufacturing requirements and recommendations 1 Scope This Technical Report collects the design and manufacturing requirements and recommendations for bridge and gantry cranes in ISO and IEC International Standards. 2 Requirements 2.1 Particular Iso International Standards for bridge and gantry cranes The International Standards marked with an x are also applicable for cranes in use. Units and symbols can be found in ISO 311) (all parts). ISO 4301-1 Cranes and lifting appliances - Classification Part 1: General Abstract: Establishes a general classification of cranes based on the number of operating cycles to be carried out during the expected