INTERNATIONAL ISO/EC STANDARD 10536-1 200 0年7月108 Second edition 2000-04-15 ldentificationcards-Contactless integrated circuit(s) cards --- Close-coupled cards - Part 1: Physical characteristics Cartes d'identification -- Cartes a circuit(s) integre(s) sans contact Cartes a couplage de proximite - Partie 1: Caracteristiques physiques 000768198 Referencenumber ISO/EC10536-1:2000(E) @ISO/EC2000 050912008778 ISO/IEC10536-1:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO/IEC2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or iso's member body inthecountryoftherequester. IsO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch PrintedinSwitzerland i IsO/IEc2000-Allrightsreserved ISO/IEC10536-1:2000(E) Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission form the specialized system for worldwide standardization. National bodies that are members of IsO or IEO participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. IsO and IEc technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. International Standards are drafted in accordance with the rules given in the ISO/IEc Directives, Part 3. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. Draft international Standards adopted by the joint technical committee are circulated to national bodies for voting Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO/lEC 10536 may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. technology, Subcommittee SC 17, ldentification cards and related devices. This second edition cancels and replaces the first edition (ISO/IEC 10536-1:1992), which has been technically revised. circuit(s) cards -- Close-coupled cards: -Part 1:Physical characteristics Part2:Dimensionsandlocationofcouplingareas Part 3: Electronic signals and reset procedures Part4:Answertoresetandtransmissionprotocols Annexes A and B of this part of ISO/IEC 10536 are for information only @ ISO/IEC 2000 -- All rights reserved 公 @ISO/IEC ISO/IEC10536-1:2000(E) Introduction IsO/lE 10536 is one of a series of International Standards describing the parameters for identification cards as defined in ISO/IEc 7810 and the.use of such cards for international interchange. This part of ISO/lEc 10536 describes the physical characteristics of close-coupled cards. This part of ISO/lEc 10536 does not preclude the incorporation of other standard technologies on the card, such as those referenced in the informative