ISO INTERNATIONAL STANDARD 9903-2 First edition 2003-02-15 Textile machinery and accessories - Main dimensions for section wires for metallic card clothing Part 2: Foot with interchaining Materiel pour I'industrie textile - Dimensions principales des fils pour garnitures de carde - Partie 2: Profil enchainé a talon autobloquant Reference number ISO 9903-2:2003(E) ISO @ISO2003 y IHS under lic itted without license from IHS Not for Resale ISO9903-2:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @IsO2003-All rights reserved ermittedwithoutlicense from IHS Not for Resale ISO 9903-2:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 9903-2 was prepared by Technical Committee ISO/TC 72, Textile machinery and machinery for dry- machinery and accessories. This first edition, together with the first edition of ISO 9903-1, cancels and replaces ISO 9903:1991, which has been technically revised. Iso 9903 consists of the following parts, under the general title Textile machinery and accessories - Main dimensions for sectionwiresformetallic card clothing: Part 1: Foot without interlocking or interchaining Part 2:Foot with interchaining ili Not for Resale aadizao No reproductic neworkingmitedwihout licenefrmH Not for Resale INTERNATIONAL STANDARD ISO 9903-2:2003(E) Textile machinery and accessories Main dimensions for section wires for metallic card clothing Part 2: Foot with interchaining Scope interchaining foot. Normative references The following referenced documents are indispensable for the application of this document. For dated references,onlytheedition citedapplies.For undated references,thelatest edition of thereferenced document (including any amendments) applies. IsO 5234, Textile machinery and accessories Metallic card clothing - Terms and definitions 3Terms, definitions and symbols For the purposes of this document, the terms and definitions and the symbols given in IsO 5234 apply. 4 Dime