ISO INTERNATIONAL STANDARD 9654 Second edition 2004-09-15 Pliers and nippers for electronics Single-purpose nippers Cutting nippers Pinces pour I'électronique - Pinces unifonction- Pinces coupantes Reference number ISO 9654:2004(E) @ ISO 2004 ISO 9654:2004(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO 2004-All rights reserved ISO 9654:2004(E) Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 9654 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 10, Assembly tools for screws and nuts, pliers and nippers. This second edition cancels and replaces the first edition (isO 9654:1989) which has been technically revised. zation'ghts reserved ii Copvriaht International Oraanization for Standardizatior ISO 9654:2004(E) INTERNATIONAL STANDARD Pliers and nippers for electronics Single-purpose nippers - Cutting nippers 1 Scope This International Standard specifies the principal dimensions of single-purpose cutting nippers for electronics and the range of diameters of test wires to be used to verify the functional performance of these nippers in accordance with ISO 9656. The general technical requirements are given in IsO 9657. The cutting nippers illustrated in this International Standard are only examples and are not intended to affect the manufacturer's design. Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. IsO 9656, Pliers and nippers for electronics-Test methods IsO 9657, Pliers and nippers for electronics General technical requirements Enamelled round copper wire 3 Dimensions 3.1End cutting nippers The principal dimensions of end cutting nippers are shown in Figure 1 and given in Table 1. The range of test wire diameters to be used is given in Table 2. ation'ghts reserved ISO9654:2004(E) Long jaws. Figure 1 End cutting nippers Table 1 End cutting nippers, principal dimensions Dimensions in millimetres Length D C d w of jaws max. max. max. ± 5 Shortjaws 112± 7 13 9 max. 22