ISO INTERNATIONAL STANDARD 9330-5 First edition 2000-06-15 Welded steel tubes for pressure purposes Technical delivery conditions Part 5: Submerged arc-welded unalloyed and alloyed steel tubes with specified low temperature properties Tubes en acier soudés pour service sous pression - Conditions techniques de livraison - Partie 5: Tubes soudés a I'arc immerge en aciers non alliés et alliés avec caracteristiques spécifiées a basse température Reference number ISO 9330-5:2000(E) ISO @ ISO 2000 Not for Resale ISO9330-5:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ISo2000-Allrightsreserved itted without license from IHS Not for Resale ISO 9330-5:2000(E) Contents Page Foreword. .iv 1 Scope 2 Normative references .. 3 Symbols.. 4 Information to be supplied by the purchaser ... 5 Manufacturing process. 6 Metallurgical properties . 7 Dimensions, masses and tolerances. ..10 8 Technical delivery conditions . .12 9 Inspection and testing ..13 10 Samples ..15 11 Test methods and results ..17 12 Marking. .22 13 Protection .22 14 Documents 22 ii HS unde from IHS Not for Resale ISO9330-5:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this part of IsO 9330 may be the subject of patent rights. isO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 9330-5 was prepared by Technical Committee ISO/TC 17, Steel, Subcommittee SC 19, Technical delivery conditions for steel tubes for pressure purposes. IsO 9330 consists of the following parts, under the general title Welded steel tubes for pressure purposes - Technicaldelivery conditions: Part 1: Unalloyed steel tubes with specified room temperature properties temperature properties Part 3: Electric resistance and induction welded unalloyed and alloyed steel tubes with specified low temperature properties Part 4: Submerged arc-welded unalloyed and alloyed steel tubes with specified elevated temperature