ISO INTERNATIONAL STANDARD 9311-1 First edition 2005-08-15 Adhesives for thermoplastic piping systems - Part 1: Determination of film properties Adhésifs pour réseaux de tuyauteries en matieres thermoplastiques- Partie 1: Détermination des propriétés des films Reference number ISO 9311-1:2005(E) @ ISO 2005 ISO 9311-1:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2005 - All rights reserved ISO 9311-1:2005(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 9311-1 was prepared by the European Committee for Standardization (CEN) in collaboration with Technical Committee ISO/TC 138, Plastics pipes, fittings and valves for the transport of fluids, Subcommittee sc 5, General properties of pipes, fittings and valves of plastic materials and their accessories- Test and CEN (Vienna Agreement). Standard..." IsO 9311 consists of the following parts, under the general title Adhesives for thermoplastic piping systems: Part 1: Determination of film properties Part 2:Determination of shear strength Part 3: Test method for the determination of resistance to internal pressure izalion'ghts reserved ili ISO 9311-1:2005(E) Contents page Foreword 1 2 Normative referenc 3 Terms and definitions 4 Safety 5 Principle. 9 Apparatus 7 Procedure 8 Expression of results 9 Test report @ ISO 2005 - All rights reserved ISO 9311-1:2005(E) Foreword This European Standard has been prepared by Technical Committee CEN/TC 193 "Adhesives" the secretariat of which is held by AENOR, in collaboration with Technical Committee ISO/TC 138 "Plastics pipes, fittings and valves for the transport of fluids". by endorsement, at the latest by February 2006, and conflicting national standards shall be withdrawn at the latest by February 2006. This European Standard is one of a series of standards as listed below: IsO 9311-1: Adhesives for thermoplastics piping systems - Part 1: Determination of film properti