ISO INTERNATIONAL STANDARD 8536-5 Second edition 2004-02-01 Infusion equipment for medical use Part 5: Burette infusion sets for single use, gravity feed Matériel de perfusion a usage médical - Partie 5: Appareils non reutilisables de perfusion a burette, a alimentation par gravite Reference number ISO 8536-5:2004(E) ISO Copyright International Organization for Standardization ISO2004 Not for Resale ISO8536-5:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below ?ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2004-All rights reserved mittedwithoutlicense from IHS Not for Resale ISO8536-5:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. Iso shall not be held responsible for identifying any or all such patent rights. ISO 8536-5 was prepared by Technical Committee ISO/TC 76, Transfusion, infusion and injection equipment for medical use. This second edition cancels and replaces the first edition (IsO 8536-5:1992), which has been technically revised. Iso 8536 consists of the following parts, under the general title Infusion equipment for medical use: Part 1: Infusion glass bottles Part 2: Closures for infusion bottles Part 3: Aluminium caps for infusion bottles Part 4: Infusion sets for single use, gravity feed Part 5: Burette infusion sets for single use, gravity feed Part 6: Freeze drying closures for infusion bottles Part 7: Caps made of aluminium-plastics combinations for infusion bottles Part 8: Infusion sets for use with pressure infusion equipment Part 9: Fluid lines for use with pressure infusion equipment -Part 10: Accessories for fluid lines for use with pressure infusion equipment Part 11: Infusion filters for use with pressure infusion equipment Copyright Internatinal Organizationforstandardizallon'ghts reserved ili Not for Resale maaaiandardizato orneworkingmitedwithout licene fromH Not for Resale INTERNATIONAL STANDARD ISO 8536-5:2004(E) Infusion equipment for medical use - Part 5: Burette infusion sets for single use, gravity feed 1 Scope 50 ml, 100 ml and 150 ml nominal capacity for med