ISO INTERNATIONAL STANDARD 8122 Second edition 2003-06-01 Textile machinery Knitting machines Number of needles for circular knitting machines of large nominal diameter Materiel pour I'industrie textile - Machines a tricoter— Nombre d'aiguilles pour les machines a tricoter circulaires de grand diametre nominal Reference number ISO 8122:2003(E) ISO @ ISO 2003 oyIHSunder Not for Resale ISO 8122:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's memberbody in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyihtinteratinal organization for Standardization @ ISO 2003 - All rights reserved itted without license from IHS Not for Resale ISO 8122:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 8122 was prepared by Technical Committee ISO/TC 72, Textile machinery and machinery for dry- cleaning and industrial laundering, Subcommittee Sc 3, Machinery for fabric manufacturing including preparatorymachineryandaccessories. This second edition cancels and replaces the first edition (IsO 8122:1988), which has been technically revised ii adizai eworkingmitedwihoutlicenefrmH Not for Resale ISO 8122:2003(E) INTERNATIONAL STANDARD Textile machinery Knitting machines Number of needles for circular knitting machines of large nominal diameter 1 Scope This International Standard specifies the usual number of needles for single-face, double-face and “links-links" circularknittingmachines oflargenominal diameter,intermsof the needlepitchorgaugeEandthemachine nominal diameter, and is able to be used as a basis for the comparison of fabrics knitted on these machines. It is not applicable to circular knitting machines with a selection of single needles. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the ref