ISO INTERNATIONAL STANDARD 8118-2 First edition 2006-01-15 Textile machinery - Weaving machine temples - Part 2: Full-width temples Machines a tisser- Templets pour métiers et machines a tisser- Partie 2: Templets de grande largeur Reference number ISO 8118-2:2006(E) @ ISO 2006 ISO 8118-2:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2006 - All rights reserved ISO 8118-2:2006(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 8118-2 was prepared by Technical Committee ISO/TC 72, Textile machinery and machinery for dry cleaning and industrial laundering, Subcommittee s 3, Machinery for fabric manufacturing including preparatory machinery and accessories. This first edition of IsO 8118-2, together with ISO 8118-1, cancels and replaces ISO 8118:1986, of which it constitutesatechnicalrevision. Iso 8118 consists of the following parts, under the general title Textile machinery- Weaving machine temples: Part 1:Temple cylinders Part 2: Full-width temples anization forStand alion'ghtsreserved ili Copvriaht International Oraanization for Standardizatior INTERNATIONAL STANDARD ISO 8118-2:2006(E) Textile machinery Weaving machine temples Part 2: Full-width temples 1 Scope This part of isO 8118 defines the basic term and gives the nomenclature, technical specifications and designation for full-width weaving machine temples used in the textile industry. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 full-width temple device used in weaving to hold the cloth to the width as presented by the reed and which is positioned as near as possible to the fell of the cloth See Figure 1. OraanizationforStanda