ISO INTERNATIONAL STANDARD 7617-2 Third edition 2003-08-01 Plastics-coated fabrics for upholstery - Part 2: Specification for PvC-coated woven fabrics Supports textiles revetus de plastique pour ameublement et garniture - Partie 2: Spécifications pour les tissus revetus de PvC Reference number ISO 7617-2:2003(E) @ ISO 2003 CopyrightIntermnational Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 7617-2:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or Iso's memberbody in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2003 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 7617-2:2003(E) Contents Page 1 Scope 1 2 Normative references 3 Technical requirements 1 4 Sampling ..... 2 5 Testing and compliance ... 2 6 3 Annex A (normative) Method of selecting test specimens .... 4 Annex B (normative) Determination of resistance to print wear 6 Annex C (normative) Determination of colour fastness to rubbing 8 Copyright Internatinal organizain far standardizatin ghts reserved ili No reproduction or networking permited without license from IHS Not for Resale ISO 7617-2:2003(E) Foreword ISO(theInternational OrganizationforStandardization)isaworldwidefederationofnational standardsbodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 7617-2 was prepared by Technical Committee ISO/TC 45, Rubber and rubber products, Subcommittee SC 4, Products (other than hoses) This third edition cancels and replaces the second edition (isO 7617-2:1994), which has been technically revised. Iso 7617 consists of the following parts, under the general title Plastics-coated fabrics for upholstery: Part 1: Specification for PvC-coated knitted fabrics Part2:Specification for PvC-coated woven fabrics Part 3: Specification for polyurethane-coated woven fabrics ationalOrganizationfor Standardization ISO 2003 - All rights reserved Not for Resale ISO 7617-2:2003(E) INTERNATIONAL STANDARD Plastics-coated fabrics for upholstery - Part 2: Specification for PvC-coated woven fabrics 1 Scope This part of IsO 7617 specifies requirements for coated fabrics for upholstered furniture, manufactured by app