ISO INTERNATIONAL STANDARD 6445 Second edition 2005-10-15 Doors Behaviour between two different climates Test method Portes— Comportement entre deux climats differents Methode d'essai Reference number ISO 6445:2005(E) @ISO2005 ISO 6445:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2005-All rights reserved ISO 6445:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with isO, also take part in the work. isO collaborates closely /with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 6445 was prepared by Technical Committee CEN/TC 33, Doors, windows, shutters, building hardware Committee ISO/TC 162, Doors and windows in parallel with its approval by the ISO member bodies. This second edition cancels and replaces the first edition (isO 6445:1989) which has been technically revised. Standard ...". @ ISO 2005 - All rights reserved ili ISO 6445:2005(E) Foreword This European Standard has been prepared by Technical Committee CEN/TC 33 "Doors windows, shutters, building hardware and curtain walling", the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of standards shall be withdrawn at the latest by December 2000 According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom This European Standard supersedes EN 79:1985 This draft is one of a series of standards for doors This standard includes six informative annexes describing the test procedures. iv ISO 2005 - All rights reserved ISO6445:2005(E) Page 2 EN 1121:2000 1 Scope This European Standard defines the test method to be used for determining the behaviour of door leaves and doorsets between two different climates. 2 Normative refererences This European Standard incorporates