ISO INTERNATIONAL STANDARD 6444 Second edition 2005-10-15 Door leaves Determination of the behaviour under humidity variations in successive uniform climates Vantaux de portes Détermination du comportement aux variations d'humidité entre des climats successifs uniformes Reference number ISO 6444:2005(E) @ ISO 2005 ISO6444:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2005 - All rights reserved ISO 6444:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. adoptedby thetechnical committees are circulated to the member bodies for voting.Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 6444 was prepared by Technical Committee CEN/TC 33, Doors, windows, shutters, building hardware Committee ISO/TC 162, Doors and windows in parallel with its approval by the ISO member bodies. This second edition cancels and replaces the first edition (IsO 6444:1980) which has been technically revised. Throughout the text of this document, read ".. this European Standard ..." to mean "... this International Standard...". eservec ii ISO 6444:2005(E) FOREWORD building hardware and curtain walling", the secretariat of which is held by AFNOR. This European Standard replaces EN 43:1985 .Methods of testing doors - Behaviour under humidity variations of doorleavesplacedinsuccessiveuniformclimates". This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 2000, and conflicting national standards shall be withdrawn at the latest by August2000 France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. This European Standard has been prepared taking into account ISO 6444 and EN 43 This draft is one of a series of standards for doors. ISO 2005 - All rights reserved ISO 6444:2005(E) Page 2 EN1294:2000 1 SCOPE This European Standard describes the method which is to be used to test the behaviour under humidity variations of door leave