ISO INTERNATIONAL STANDARD 6442 Second edition 2005-10-15 Door leaves General and local flatness Measurement method Vantaux de portes Planéites générale et locale Méthode de mesure Reference number ISO 6442:2005(E) @ ISO 2005 ISO 6442:2005(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ?ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ISO 2005-All rights reserved ISO 6442:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. adopted by thetechnical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 6442 was prepared by Technical Committee CEN/TC 33, Doors, windows, shutters, building hardware Committee ISO/TC 162, Doors and windows in parallel with its approval by the ISO member bodies. This second edition cancels and replaces the first edition (isO 6442:1981) which has been technically revised. Throughout the text of this document, read ".. this European Standard ..." to mean "... this International Standard...". anizationfor'Stand ii ISO6442:2005(E) Page 2 EN 952:1999 Foreword windows, shutters and building hardware", the secretariat of which is held by AFNOR. This European Standard supersedes EN 24:1974. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 2000, and conflicting national According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom This draft standard is one of a series of standards for doors. This standard has been prepared taking into account EN 24:1974 and prEN 224, and supersedes both. @ ISO 2005 - All rights reserved ISO 6442:2005(E) Page 3 EN 952:1999 Scope This standard can be applied to all rectangular door leaves. The standard specifies the method to be used to measure the deviations in