ISO INTERNATIONAL STANDARD 5655 Third edition 2000-10-01 Photography Industrial radiographic films (roll and sheet) and metal intensifying screens Dimensions Photographie Films radiographiques industriels (rouleaux et feuilles) et écrans intensificateurs en métalDimensions Reference number ISO 5655:2000(E) (so @ ISO 2000 ISO5655:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liabilty in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 2000 - All rights reserved ISO 5655:2000(E) Contents Page Foreword.. 1 Scope. 2 Normativereferences.. 3 Conditions for measurement of dimensions Films in rolls.... 5 Films in sheets... 6 Package marking .. 7 Dimensions of intensifying screens Annex A (informative) Quantity packaging for sheets . 8 zaltionserved ii ISO 5655:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO5655 was prepared by Technical Committee ISO/TC 42, Photography. This third edition cancels and replaces the second edition (isO 5655:1993), of which it constitutes a technical revision based upon ANSI/BAPM IT1.15-1994. Annex A of this International Standard is for information only. ISO 2000 - All rights reserved ISO 5655:2000(E) INTERNATIONAL STANDARD Photography Industrial radiographic films (roll and sheet) and metal intensifying screens Dimensions Scope radiographic roll and sheet films and metal intensifying screens. It also specifies package markings. The shaping of the corners of screens is not specified. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. IsO 1:1975, Standard reference temperature for industrial length measurements. Iso 554:1976, Standard atmospheres for conditioning and/or testing — Specifications. 3 Conditions for measurement of dimensions under atmospheric conditions of (23 ± 2) °C and (50 ± 5) % relativ