ISO INTERNATIONAL STANDARD 4762 Fourth edition 2004-03-01 Hexagon socket head cap screws Vis a tete cylindrique a six pans creux Reference number ISO 4762:2004(E) @ ISO 2004 Copyright Intemational Organization for Standardization Nepreprudectin or nenerking sewiteswithoutliense from Is Not for Resale ISO 4762:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or Iso's memberbody in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yghematganzatoSdadzati @ ISO 2004 - All rights reserved No'reproduction or networking permited without license from IHS Not for Resale ISO 4762:2004(E) Contents Page 1 Scope 2 Normative references 3 Dimensions .... 2 4 Requirements and reference International Standards 9 5 Designation . 9 Annex A (informative) Masses 10 Copyright Internatinal organizain for standardizatin ghts reserved ili Ne repruduetin or nutnerkin semiteswithoutlicense from IHs Not for Resale ISO 4762:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 4762 was prepared by Technical Committee ISO/TC 2, Fasteners. This fourth edition cancels and replaces the third edition (isO 4762:1997), which has been technically revised. @ ISO 2004 - All rights reserved onal Organization for Standardizatior Not for Resale ISO 4762:2004(E) INTERNATIONAL STANDARD Hexagon socket head cap screws 1 Scope This International Standard specifies the characteristics of hexagon socket head cap screws with coarse pitch thread from M1,6 up to and including M64 and product grade A. For approximate masses of screws see Annex A. If, in special cases, specifications other than those listed in this International Standard are required, they should be selected from existing International Standards, e.g ISO 261, ISO 888, ISO 898-1, ISO 965-2. ISO 3506-1, ISO 8839 and ISO 4759-1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated (including any amendments) applies. Iso 225, Fasteners — Bolts, screws, studs and nuts Symbols and designations of dimensions ISO 261, ISO general-purpose metric screw threads - General plan Iso 888, Bolts, screws and studs — Nominal lengths, and thread lengths for general purpose bolts Iso 898-1, Mechanical