ISO INTERNATIONAL STANDARD 4714 Second edition 2000-03-15 Composition cork Specifications, sampling, packaging and marking Agglomere composéde liege-Specifications,échantillonnage, emballage et marquage Reference number ISO 4714:2000(E) ISo @ISO2000 ISO4714:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is atrademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body inthecountryoftherequester. ISO copyright office Casepostale56.CH-1211Geneva20 Tel. + 41 22 749 01 11 Fax + 4122734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland ISO 2000 - All rights reserved IS0 4714:2000(E) Foreword Commission(IEC)onall mattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. isO shall not be held responsible for identifying any or all such patent rights. InternationalStandardISO4714waspreparedbyTechnicalCommitteeISO/TC87,Cork. maranaionangaantorstandianbalianserved IS04714:2000(E) Introduction Composition cork is a material withmany different compositions and applications. ThisInternational Standardgivesthespecificationsrequiredtoprovide itsminimumcharacterization. Performance requirements related to an intended use are specified in relevant International Standards Composition cork of low thickness may be obtained as such by direct compression ormay be obtained either by reslicing blocks or by unwinding and cutting cylindrical rolls. @ISO2000-Allrightsreserved ISO 4714:2000(E) INTERNATIONALSTANDARD Composition cork Specifications, sampling, packaging and marking 1 Scope This International Standard establishes the minimum requirements for agglomerated composition cork in the sheet form and specifies the requirements for sampling, packaging and marking. 2Normative references this International Standard. For dated references, subsequent amendments to, or revisions of, any of these undated references, the latest edition of the normative document referred to applies. Members of isO and IEC maintainregistersofcurrentlyvalidInternationalStandards. ISO633, Cork-Vocabulary. IsO2859-1,Samplingproceduresfor inspectionby attributes-Part1:Samplingschemes indexedby acceptance quality limit (AQL) for lot-by-lot inspection ISo7322,Compositioncork-Testmethods 3 Terms and definitions For the purposes of this International Standard, the terms and definitions given in ISO 633 and the following apply. 3.1 compositioncork agglomerated composition cork product obtained from the agglutination of cork granules with the addition of a binder which is not derived from cork cells 3.2 rubbercork granules or as a binder 4 Sampling shall be in accord