ISO INTERNATIONAL STANDARD 4190-5 Third edition 2006-11-01 Lift (Elevator) installation - Part 5: Control devices, signals and additional fittings Installation d'ascenseurs- Partie 5: Dispositifs de commande et de signalisation et accessoires complémentaires Reference number ISO 4190-5:2006(E) @ ISO 2006 ISO 4190-5:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below ? ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ISO2006-All rightsreserved ISO 4190-5:2006(E) Contents Page Foreword. iv Introduction 1 Scope 2 Normative references 3 Specifications relating to controls. 4 Handrail. .8 Annex A (normative) Special systems. Annex B (informative) Particular requirements. 14 Annex C (normative) Representative symbols .. Bibliography.... 19 raanizationforStanda alion'ghts reserved ili ISO 4190-5:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 4190-5 was prepared by Technical Committee ISO/TC 178, Lifts, escalators and moving walks. This third edition cancels and replaces the second edition (IsO 4190-5:1987), which has been technically revised. ISO 4190 consists of the following parts, under the general title Lift (Elevator) installation1): Part 1: Class I, Il, Ill and VI lifts Part 2: Class /V lifts Part 3: Service lifts class V Part 5: Control devices, signals and additional fittings Part6:PassengerliftstobeinstalledinresidentialbuildingsPlanningandselection 1) The title, which differs in various respects in the other, previously published, parts, is to form the subject of a Technical Corrigendumforeachof the parts concerned. @ ISO 2006 - All rights reserved ISO 4190-5:2006(E) Introduction This third edition of isO 4190-5 takes into account the latest studies concerning ergonomics and the needs of variouspeop