ISO INTERNATIONAL STANDARD 4148 Fourth edition 2004-11-01 Road vehicles Special warning lamps Dimensions Vehicules routiers Feux spéciaux d'avertissement - Dimensions Reference number ISO 4148:2004(E) Copyright International Organization for Standardization @ISO2004 Not for Resale ISO 4148:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2004-All rights reserved mittedwithoutlicense from IHS Not for Resale ISO 4148:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 4148 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 8, Lighting and signalling. This fourth edition cancels and replaces the third edition (isO 4148:1998), which has been technically revised. It also incorporates the Draft amendment ISO 4148:1998/DAmd1. yhemainaanaioSandardizato orneworkingmitedwithout licene fromH Not for Resale INTERNATIONAL STANDARD ISO 4148:2004(E) Road vehicles Special warning lamps Dimensions Scope This International Standard specifies the dimensions of special warning lamps for road vehicles, in order to such devices in a vertical cross-section of the projected beam. It also specifies (see Annex A) methods for testing the magnetic-base mountings used to install special warning lamps directly on the steel sheet of the roof or body of a vehicle (special warning lamps of Category D). NOTE In certain countries and international bodies, the term "light" is sometimes used instead of "lamp". Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. Iso 2813, Paints and varnishes - Determination of specular gloss of non-metallic paint films at 20 degrees, 60 degrees and 85 degrees Definitions, tests and requirements IsO 4130, Road vehicles - Three-dimensional reference system and fiducial marks - Definitions Iso 4165, Road vehicles —Electrica