ISO INTERNATIONAL STANDARD 366-4 Second edition 2005-05-01 Textile machinery and accessories - Reeds - Part 4: Dimensions and designation of plastic- bound metal reeds Materiel pour I'industrie textile-Peignes- Partie 4: Dimensions et désignation des peignes metalliques a ligature plastique Reference number ISO 366-4:2005(E) @ ISO 2005 Copyright International Organization for Standardization Not for Resale ISO 366-4:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's memberbody in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CopyightInternatinal organization for Standardization @ ISo 2005 - All rights reserved vithout license from IHS Not for Resale ISO 366-4:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 366-4 was prepared by Technical Committee ISO/TC 72, Textile machinery and machinery for dry cleaning and industrial laundering, Subcommittee Sc 3, Machinery for fabric manufacturing including preparatorymachineryandaccessories. This second edition cancels and replaces the first edition (IsO 366-4:1992), which has been technically revised Iso 366 consists of the following parts, under the general title Textile machinery and accessories - Reeds: Part 1: Dimensions of pitch bound reeds Part 2:Dimensions and designation of metalreeds withplatebaulk Part 3: Dimensions and designation of metal reeds with double-spring baulk Part 4:Dimensions and designation of plastic-bound metal reeds Part 5:Dimensions anddesignation of profil capsulas onal organizatinforsahdardizllonights reserved ii adzi rneworking emitedwithoutliensfrmH Not for Resale INTERNATIONAL STANDARD ISO366-4:2005(E) Textile machinery and accessories Reeds - Part 4: Dimensions and designation of plastic-bound metal reeds 1 Scope This part of Iso 366 specifies the dimensions and designation of plastic-bound metal reeds for weaving machines. For the strip steel used in the manufacture of dents of reeds, see IsO 9473-1 and 9473-2. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. capsulas IsO 9473-1, Textile machinery and accessories Strip steel for dents of reeds Part 1: Cold rolled strip steel steel Dimensions The indicated dimensions of plastic-bound metal reeds shown in Figure 1 and given in Table 1,