ISO INTERNATIONAL STANDARD 3098-3 Second edition 2000-05-01 Technical product documentation - Lettering - Part 3: Greek alphabet Documentation technique de produits Ecriture- Partie 3: A/phabet grec Reference number A ISO 3098-3:2000(E) ISO @ ISO 2000 IHSunder ISO 3098-3:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the @ ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ IsO 2000 - All rights reserved 1/9972545001 itted without license from IHS ISO3098-3:2000(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO memberbodies).TheworkofpreparingInternationalStandardsisnormallycarried outthroughISOtechnica committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas liaison with sO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEc Directives, Part 3. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this part of isO 3098 may be the subject of patent International Standard ISO 3098-3 was prepared by Technical Committee ISO/TC 10, Technical drawings, product definition and related documentation, Subcommittee SC 1, Basic conventions. This second edition of IsO 3098-3 cancels and replaces the first edition (isO 3098-2:1984), which has been technically revised. IsO 3o98 consists of the following parts, under the general title Technical product documentation Lettering: Part O: General requirements [becomes Part 1 with the next revision] Part 2: Latin alphabet, numerals and marks Part 3: Greek alphabet -Part 4:Diacritical and particular marks for the Latin alphabet -Part 5: CAD lettering of the Latin alphabet, numerals and marks Part 6: Cyrillic alphabet ili aanar andadizatin 1/9972545001 tetworkingpemittedwithoutlicensefromHS INTERNATIONALSTANDARD ISO 3098-3:2000(E) Technical product documentation Lettering Part 3: Greek alphabet 1 Scope This part of IsO 3o98 specifies use of the Greek alphabet as symbols in technical drawings and associated documents. It primarily concerns letters written with the aid of stencils, but is equally applicable to freehand lettering or other appropriate methods. 2Normative reference this part of isO 3o98. For dated references, subsequent amendments to, or revisions of, this publication do noi of applying the most recent edition of the normative document indicated below. For undated references, the latest edition of the normative document referred to applies. Members of IsO and IEC maintain registers of currently valid International Standards. IsO 3098-0:1997, Technical product documentation Lettering - Part 0: General requirements. 3 General requirements and dimensions