ISO INTERNATIONAL STANDARD 24233 First edition 2008-02-15 Tools for moulding Tool specification sheet for diecasting dies Outillage de moulage - Formulaire de spécifications d'outils pour moulespourfonderiesouspression Reference number ISO 24233:2008(E) @ ISO 2008 ISO24233:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In COPYRIGHTPROTECTEDDOCUMENT ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISo 2008 - All rights reserved ISO24233:2008(E) Contents Page Foreword. .. iv 1 Scope. 2 Normative references . 3 Terms and definitions... 4 Use of the specification sheet... Annex A (normative) Tool specification sheet for diecasting dies... Iso2008-All rights reserved ii ISO 24233:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 24233 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 8, Tools for pressingandmoulding iv @ ISo 2008 -Allrights reserved INTERNATIONALSTANDARD ISO 24233:2008(E) Tools for moulding Tool specification sheet for diecasting dies 1 Scope This International Standard presents a tool specification sheet for diecasting dies, for use both when requesting (at the tendering stage) and when ordering the tools. The sheet specifies the data necessary for material acquisition, equipment and the structural design of diecasting dies, including the tool surfaces, as well as information relating to machine-specific data, types of operation and warranty. This International Standard is not applicable to compression moulds or injection moulds. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. Iso 12165, Tools for moulding - Components of compression and injection moulds and diecasting dies - Terms and symbols 3 Terms and definitions For the purposes of this document, the terms and definitions given in IsO 12165 apply. 4 Use of the specification sheet The use of the specification she