ISO INTERNATIONAL STANDARD 23815-1 First edition 2007-09-15 Cranes Maintenance - Part 1: General Appareils de levage a charge suspendue - Entretien- Partie1:Généralités Reference number ISO 23815-1:2007(E) @ ISO 2007 IHSunder itted without license from IHS Not for Resale ISO 23815-1:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT @ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISo 2007 - All rights reserved I without license from IHS Not for Resale ISO 23815-1:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 23815-1 was prepared by Technical Committee ISO/TC 96, Cranes, Subcommittee SC 5, Use, operation andmaintenance. IsO 23815 consists of the following parts, under the general title Cranes Maintenance: Part 1:General ii adizai eworkingmitedwihoutlicenefrmH Not for Resale INTERNATIONALSTANDARD ISO23815-1:2007(E) Cranes Maintenance Part 1: General 1 Scope This International Standard establishes required practices for the maintenance of cranes by owners/users. Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the cited edition applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO 4306-1,Cranes—Vocabulary—Part 1:General Iso 4306-2, Cranes—Vocabulary—Part 2: Mobile cranes Iso 4306-3, Cranes — Vocabulary—Part 3: Tower cranes Iso 4309, Cranes - Wire ropes Care, maintenance, installation, examination and discard IsO 9927-1, Cranes—Inspections—Part 1: General IsO 12480-1:1997, Cranes — Safe use — Part 1: General 3Terms and definitions and IsO 12480-1, and the following, apply. 3.1 maintenance set of activities intended to keep a crane in, or to restore it to, a state in which it can perform its required function EXAMPLE Monitoring, test and measurement, replacement, adjustment, repair, administrative action (in some cases). 3.2 p