ISO INTERNATIONAL STANDARD 23813 First edition 2007-09-15 Cranes Training of appointed persons Appareilsde levagea charge suspendue-Formation pourles personnes désignées Reference number ISO 23813:2007(E) @ ISO 2007 THS under ted without license from IHS Not for Resale ISO23813:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shali not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In COPYRIGHTPROTECTEDDOCUMENT @ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007 - All rights reserved ted without license from IHS Not for Resale ISO 23813:2007(E) Contents Page Foreword. iv 1 Scope 1 2 Normative references 3 Terms and definitions... 4 Prerequisite aptitudes and knowledge 5 General... 2 6 Training objectives . 7 Content of training .... Annex A (informative) Appointed person's checklist..... Annex B (informative) Course content and programme Copyright International Organizaion for Standardizalon ghts reserved ii IHSunder ie from IHS Not for Resale ISO 23813:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 23813 was prepared by Technical Committee ISO/TC 96, Cranes, Subcommittee SC 5, Use, operation and maintenance. ional Organization for Standardization ISO 2007 - All rights reserved INTERNATIONAL STANDARD ISO23813:2007(E) Cranes Training of appointed persons 1 Scope This International Standard specifies the minimum training needed to impart the requisite knowledge for a person appointed to control and manage the lifting operations of cranes. It is not applicable to the additiona training required for those persons controlling and managing lifting operations involving dangerous goods or hazardous areas. NOTE 1 Responsibilities for the performance of tasks are given in IsO 12480-1. NOTE2 For the training of drivers and operators, slingers and signallers, see IsO 9926-1 and IsO 23853, respectively. Normative references references, only the cited edition applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO 4306-1, Cranes—Vocabulary—Part 1: General ISO9926-1, Cranes—Training of drivers—Part 1:General Iso 12480-1:1997, Cranes — Safe use — Part 1: