ISO INTERNATIONAL STANDARD 2336-2 Second edition 2006-08-01 Hacksaw blades - Part 2: Dimensions for machine blades Lames de scies droites a métaux Partie 2: Dimensions des lames a machine Reference number ISO 2336-2:2006(E) @ISO2006 ISO 2336-2:2006(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is atrademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In thie unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ? ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, Iso's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2006 - All riahts reserved ISO2336-2:2006(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been InternationalElectrotechnicalCommission(iEC)onallmattersofelectrotechnicalstandardization International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 2336-2 was prepared by Technical Committee ISO/TC 29, Small tools. This second edition cancels and replaces the first edition (IsO 2336-2:1996), which has been technically revised. Iso 2336 consists of the following parts, under the general title Hacksaw blades: Part 1: Dimensions for hand blades Part2:Dimensionsformachineblades "ahts reserved ili INTERNATIONAL STANDARD ISO 2336-2:2006(E) Hacksaw blades Part 2: Dimensions for machine blades 1 Scope This part of IsO 2336 specifies the dimensions of machine hacksaw blades. It is applicable to single-edge blades of lengths from 300 mm up to 700 mm, the tooth pitch of which is no greater than 8,5 mm. Normative references references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO 2768-1, General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indications Dimensions 3.1 General All dimensions and tolerances are given in millimetres. Tolerances not specified shall be of tolerance class “m" inaccordancewithISO2768-1. 3.2 Dimensions The dimensions shown in Figure 1 are given in Table 1, with tooth pitch, P, and the number of teeth, N, in 25 mm. The blade length, ly, is the distance between centres of pin holes of diameter d. It is recommended that the centre of the pin hole be located on the centreline of the blade. Designation Machine hacksaw blades according to this part of IsO 2336 shall be designated as fo