ISO INTERNATIONAL STANDARD 23206 First edition 2005-06-01 Agricultural wheeled tractors and attachments Front loaders Carriages for attachments Tracteurs agricoles a roues et accessoires - Chargeuses frontales - Accouplementssurstructurespourlesaccessoires Reference number ISO 23206:2005(E) @ ISO 2005 ISO 23206:2005(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ?ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO2005-All rights reserved ISO 23206:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEC Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. forestry, Subcommittee SC 4, Tractors. zalion'ghts reserved ii Copvriaht International Oraanization for Standardizatior INTERNATIONALSTANDARD ISO 23206:2005(E) Agricultural wheeled tractors and attachments Front loaders Carriages for attachments Scope 7 This International Standard specifies the dimensions and clearance requirements for the carriages for attachments on agricultural tractors and machines equipped with front loaders and having a maximum load capacity of 30 kN and a maximum unladen tractor weight of 7 500 kg. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 frontloader detachable unit consisting of lifting arms and fastening devices designed to be mounted on a frame on the front of a tractor and equipped with a carriage for mounting various attachments See Figure 1. 2.2 attachment working device to be mounted on and operated with a front loader See Figure 1. 3 2 Key attachment 2 carriage 3 lifting arm Figure 1 Tractor with front loader and an attachment alion'ghts reserved 1 ISO 23206:2005(E) 2.3 carriage coupler assembly at the front loader arm end for mounting various attachments to the front loader See Figure 1. 2.4 maximum load capacity when operating the lift and/or tilt cylinders See Figure 2. Dimensions in millimetres 800 /30kN Figure 2 2—Maximum load capacity 3 Dimensions and clearances The carriage dimensions and the dimensions associated with the attachment shall be in accordanc