BRITISH STANDARD BS ISO 20160:2006 Implants for surgery - Metallic materials Classification of microstructures for 2023 alpha+beta titanium alloy bars uel ICS 11.040.40 BSi NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW British Standards BS ISO 20160:2006 National foreword This British Standard is the UK implementation of ISO 20160:2006. The UK participation in its preparation was entrusted to Technical Committee CH/150/1, Materials for surgical implants. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. s of 2 Jan 2023. 8 Version correct y of Birmingham. Licensed copy: University This British Standard was Amendments/corrigendaissued sincepublication published under the authority of the Standards Policy and Strategy Date Comments Committee on 28 February 2009 CBSI 2009 ISBN 978 0 580 53153 8 BS ISO 20160:2006 INTERNATIONAL ISO STANDARD 20160 First edition 2006-05-01 Corrected version 2006-09-15 2023. Implants for surgery Metallic of 2Jan materials Classification of microstructures for alpha+beta titanium se alloy bars correct Implants chirurgicaux- Materiaux métalliques Classification des Version microstructures des barres en alliages de titane alpha+beta of Birmingham. University copy: Licensed Reference number ISO 20160:2006(E) @ ISO 2006 BS ISO 20160:2006 ISO 20160:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below f 2 Jan 2023. 8 Version correct f Birmingham. I copy: University Licensed @ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISO's member body in the country of the requester. ISO copyright office Case postale 56: CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2006 - All rights reserved BS ISO 20160:2006 ISO 20160:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies established has the right to be represented on that committee. International organizations, governmental and International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 2023 adopted by the technical committees are circulated to the member bodies for voting. Publication as an as rights. isO shall not be held responsible for identifying any or all such patent rights. ISO 20160 was prepared by Technical Committee ISO/TC 150, Implants for surgery, Subcommittee SC 1, Materials. This corrected version of ISO 20160:2006 incorporates the following corrections: uel symbols; Bi University @ISO 2006-All rights reserved ili BS IS0 20160:2006 ISO 20160:2006(E) Introduction Some IsO Standards on alpha+beta titanium implant materials refer