ISO INTERNATIONAL STANDARD 18895 Flrst edition 2006-04-15 Footwear Test methods for shanks Fatigue resistance Chaussures — Methodes d'essai pour cambrions - Résistance a la fatigue Reference number ISO 18895:2006(E) @ ISO 2006 ISO18895:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In @ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2006 - All rights reserved ISO 18895:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote rights. IsO shall not be held responsible for identifying any or all such patent rights. Technical Committee ISO/TC 216, Footwear, in parallel with its approval by the ISO member bodies. izalion'ghts reserved ii ISO 18895:2006(E) Page 2 EN12958:2000 Contents Page Foreword Scope .. 2 Normative references. 3 4 Apparatus and materials 5 Sampling and conditioning 6 Test method 7 Expression of results Test report @ ISO 2006 - All rights reserved ISO 18895:2006(E) Page 3 EN 12958:2000 Foreword This European Standard has been prepared by Technical Committee CEN/TC 309 "Footwear", the secretariat of which is held by AENOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 2000, and conflicting national standards shall be withdrawn at the latest by August 2000. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg. Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. Conviht International Oranization far standardizalion'ghts reserved Copvriaht International Oraanization for Standardization ISO 18895:2006(E) Page 4 EN 12958:2000 Scope This European standard specifies a method for assessing the fatigue resistance of steel shanks used for therein