ISO INTERNATIONAL STANDARD 18185-2 First edition 2007-04-15 Freight containers Electronic seals - Part 2: Application requirements Conteneurs pour le transport de marchandises - Scelles électroniques Partie 2: Exigences d'applications Reference number ISO 18185-2:2007(E) @ISO 2007 py IHS under lic itted without license from IHS Not for Resale ISO 18185-2:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007 - All rights reserved edwithoutlicense from IHS Not for Resale ISO 18185-2:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 18185-2 was prepared by Technical Committee ISO/TC 104, Freight containers, Subcommittee SC 4, ldentificationand communication. IsO 18185 consists of the following parts, under the general title Freight containers - Electronic seals: Part 1: Communication protocol Part 2:Application requirements Part 3:Environmental characteristics Part 4: Data protection Part 5:Physical layer ili ISO 18185-2:2007(E) Introduction This part of ISO 18185 was prepared by ISO Technical Committee 104/Subcommittee 4/Working Group 2, using the drafting conventions of ISO/IEC Directives, Part 2. This part of isO 18185 provides a system for the identification and presentation of information about freight container electronic seals. The identification system provides an unambiguous unique identification of the container seal and its status. identification and a method to determine whether a freight container's seal has been opened. @ ISO 2007 -All rights reserved itted without license from IHS Not for Resale INTERNATIONAL STANDARD ISO 18185-2:2007(E) Freight containers Electronic seals Part 2: Application requirements 1 Scope This part of IsO 18185 specifies a freight container seal identification system, with an associated system for verifying the accuracy of use, having: a seal status identification system; a battery status indicator; a unique seal identifier including the identification of the manufacturer; a seal (tag) type. This part of ISO 18185 is used in c