ISO INTERNATIONAL STANDARD 17709 First edition 2004-10-15 Footwear Sampling location, preparation and duration of conditioning of samples and test pieces Chaussures-Localisation de I'échantillonnage, preparation et duree de conditionnement des échantillons et éprouvettes Reference number ISO 17709:2004(E) @ISO 2004 ed by IHS ur Not for Resale ISO 17709:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CopyightInternatinal organization for Standardization @ Iso 2004 - All rights reserved vithout license from IHS Not for Resale ISO 17709:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Is0 17709 was prepared by the European Committee for Standardization as EN 13400:2001. This International Standard includes corrigendum EN 13400:2001/AC:2003 and was adopted under a specia member bodies. Standard..." ii ISO 17709:2004(E) Introduction CEN/TC 309 has established European Standards on test methods to determine the properties of components for The test methods need sample taking on the shoe or on the shoe component. It is necessary: -to have a conditioning time (see EN 12222) before the analysis beginning Copyright Interna national Organization for Standardization @ISO2004-All rights reserved vithout license from IHS Not for Resale ISO 17709:2004(E) EN13400:2001 (E) 1Scope This European Standard specifies the sampling location, preparation and duration of conditioning of samples and properties for the end use. These are the general conditions unless otherwise stated in the corresponding test method. 2Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequen