ISO INTERNATIONAL STANDARD 17693 First edition 2004-10-15 Footwear Test methods for uppers Resistance to damage on lasting Chaussures Methodes d'essai des tiges - Aptitude au montage Reference number ISO 17693:2004(E) @ ISO 2004 Not for Resale ISO17693:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CopyightInternatinal organization for Standardization @ Iso 2004 - All rights reserved vithout license from IHS Not for Resale ISO 17693:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through ISO non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. IsO 17693 was prepared by the European Committee for Standardization as EN 13511:2001. This International Standard includes corrigendum EN 13511:2001/AC:2003 and was adopted under a special member bodies. Standard..." ganzadardizallnghtsreserved ili adzi rneworking emitedwithoutliensfrmH Not for Resale ISO 17693:2004(E) EN 13511:2001 (E) 1 Scope This European Standard specifies a test method to determine the lastability of uppers or complete upper assembly irrespective of the material in order to assess the suitability for the end use. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For footwear. prEN IsO 2418, Leather - Chemical, physical, mechanical and fastness tests - Sampling 3 Terms and definitions For the purposes of this European Standard, the following terms and definitions apply 3.1 resistance to damage on lasting ability of a material to be stretched simultaneously in all directions (distended) without being damaged 3.2 upper materials forming the outer face of the footwear which is attached to the sole assembly and covers the upper dorsal materials that are visible are included, no account should be taken of underlying materials 3.3 complete upper assembly finished upper, fully seamed