ISO INTERNATIONAL STANDARD 17591 First edition 2002-11-01 Machinery for forestry Knuckleboom log loaders Identification terminology, classification and component nomenclature Matériel forestier- Chargeuses de grumes a bras articule Terminologie didentification,classificationetnomenclaturedesélements Reference number ISO 17591:2002(E) ISO @ ISO 2002 ISO 17591:2002(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii @ ISO 2002 - All rights reserved ISO 17591:2002(E) Foreword member bodies). The work of preparing International Standards is normally carried out through IsO technical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 17591 was prepared by Technical Committee ISO/TC 23, Tractors and machinery for agriculture and forestry, Subcommittee SC 15, Machinery forforestry. @ISO2002-Allrightsreserved ii INTERNATIONAL STANDARD ISO17591:2002(E) Machinery for forestry Knuckleboom log loaders ldentification terminology, classification and component nomenclature 1 Scope This International Standard defines identifying terms, specifies a means of classification and gives a nomenclature of the various configurations of this type of mobile forest machine. 2 Normative reference The following normative document contains provisions which, through reference in this text, constitute provisions oi this International Standard. For dated references, subsequent amendments to, or revisions of, this publication do not possibility of applying the most recent edition of the normative document indicated below. For undated references currently valid International Standards. IsO 6814, Machinery for forestryMobile and self-propelled machineryTerms, definitions and classification 3Terms and definitions For the purposes of this International Standard, the following terms and definitions apply. NOTE The figures in this International Standard are intended to illustrate basic concepts rather than any existing machines or all possible boom configurations. 3.1 General terms Machines or components defined by their mounting configuration and boom geometry 3.1.1 knuckleboom log loader class of log loader characterized by a swing-to-load machine with articulated booms, grapple and supporting structure designed to grab, lift, swing and place trees or parts of trees NOTE It is classified as such in accordance with ISO 6814. 3.1.2 boomset system of pivoting members between the main boom pivot and the grapple pivot 3.1.3 upper structure assembly of components of the loader above the swing bearing @ ISO 2002 - All rights reserved 1 ISO17591:2002(E) 3.1.4 heel solid struct