ISO INTERNATIONAL STANDARD 17082 First edition 2004-06-01 Pneumatic fluid power Valves Data to be included in supplier literature Transmissions pneumatiquesDistributeurs- Données a inclure dans la documentation des fournisseurs Reference number A ISO 17082:2004(E) ISO @ ISO 2004 ISO 17082:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ? ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2004 - All rights reserved ISO 17082:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 17082 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 5 Control products and components izalion'ghtsreserved ii ISO 17082:2004(E) Introduction circuit. Typical components found in such systems are pneumatic valves. These devices control flow direction, pressure or flow rate of air in the circuit. Convriaht International Oraanization for Standardization @ Iso 2004 - All rights reserved INTERNATIONAL STANDARD ISO 17082:2004(E) Pneumatic fluid power Valves Data to be included in supplier literature 1 Scope This International Standard specifies which data are to be included in the manufacturer's supplier literature that accompanies any kind of pneumatic valve. These data are vital in selecting the proper valve for a particular application. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso 1219-1, Fluid power systems and components - Graphic symbols and circuit diagrams — Part 1: Graphic symbols IsO 3448, Industrial liquid lubricants —/sO viscosity classification Characteristics and requirements Iso