ISO INTERNATIONAL STANDARD 17063 First edition 2003-11-15 Earth-moving machinery Braking systems of pedestrian-controlled machines Performance requirements and test procedures Engins de terrassement- Dispositifs de freinage des engins a conducteuraccompagnantExigencesdeperformanceetmodes opératoires d'essai Reference number ISO 17063:2003(E) ISO @ ISO 2003 yIHS under Not for Resale ISO 17063:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyihtinteratinal organization for Standardization @ ISO 2003 - All rights reserved itted without license from IHS Not for Resale ISO17063:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 17063 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee SC 2. Safety requirements and humanfactors. ii eworkingmitedwihoutlicenefrmH Not for Resale INTERNATIONALSTANDARD ISO17063:2003(E) Earth-moving machinery Braking systems of pedestrian- controlled machines Performance requirements and test procedures 1 Scope This International Standard specifies minimum performance criteria and tests for braking systems, enabling uniformassessmentofthebrakingcapabilityofpedestrian-controlled,self-propelledearth-movingmachinery is applicable to both service and parking brakes. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso 6014, Earth-moving machinery- Determination of ground speed IsO 6016, Earth-moving machinery - Methods of measuring the masses of whole machines, their equipment and components Iso 6165, Earth-moving machinery— Basic types - Vocabulary 3 Terms and definitions For the purposes of this document, the terms and definitions given in IsO 6165 and the following apply. 3.1 pedestrian controlled machine machine 3.2 br