ISO INTERNATIONAL STANDARD 14790 Second edition 2005-02-01 Snowboard plate-bindings without a release mechanism Requirements and test methods Fixations de surf des neiges de type a plaque sans mécanisme de déclenchement Exigences et méthodes d'essai Reference number ISO 14790:2005(E) Copyright International Organization for Standardization @ISO2005 itted without license from IHS Not for Resale ISO14790:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below ?ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2005-All rightsreserved mittedwithoutlicense from IHS Not for Resale ISO 14790:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of paten rights. IsO shall not be held responsible for identifying any or all such patent rights. Subcommittee SC 3, Ski bindings. been technically revised. Coyghtnemanalanzaadardizao'ghtsreved ili yhemainaanaioSandardizato orneworkingmitedwithout licene fromH Not for Resale INTERNATIONAL STANDARD ISO 14790:2005(E) Snowboard plate-bindings without a release mechanism Requirements and test methods 1 Scope This International Standard specifies the essential requirements (including certain quality aspects) of snowboard plate bindings without release mechanism. This International Standard is applicable to non-releasable snowboard plate bindings for adults and children. This International Standard does not apply to snowboard plate bindings with a release mechanism or to snowboard soft bindings. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO6004:1991,Apine skis—Skibinding screwsRequirements Iso 9838:1991, Alpine ski-bindings — Test soles for ski-binding tests Iso 11087:2004, Alpine ski-bindings Retention devices - Requirements and test methods Iso 11634:1996, Snowboard-boots — Interface with ski-binding 3Terms and definitions For the purposes of this document, the following