ISO INTERNATIONAL STANDARD 14617-14 First edition 2004-11-15 Graphical symbols for diagrams Part 14: Devices for transport and handling of material Symbolesgraphiquespourschémas- Partie 14: Dispositifs pour le transport et la manutention des materiaux Licensed copy: Imperial College , Reference number ISO 14617-14:2004(E) @ ISO 2004 ISO 14617-14:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe isatrademarkof AdobeSystemsIncorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In C ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means isO's memberbody in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ISO2004-All rights reserved ISO14617-14:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies non-governmental, in liaison with isO, also take part in the work. sO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 14617-14 was prepared by Technical Committee ISO/TC 10, Technical product documentation, Subcommittee SC 10, Process plant documentation and tpd-symbols. Iso 14617 consists of the following parts, under the general title Graphical symbols for diagrams: Part 1: General information and indexes Part 2: Symbols having general application Part 3: Connections and related devices Part 4: Actuators and related devices Part 5: Measurement and control devices Part 6: Measurement and control functions Part 7: Basic mechanical components Part 8: Valves and dampers Part 9: Pumps, compressors and fans Part 10: Fluid power converters Part 11: Devices for heat transfer and heat engines Part 12: Devices for separating, purification and mixing Part 13: Devices for material processing Part 14:Devices fortransport and handling of material Part 15: Installation diagrams and network maps @ ISO 2004 - All rights reserved ii ISO 14617-14:2004(E) Introduction diagrams used in technical applications. This work has been, and will be, performed in close co-operation between ISO and IEC. The ultimate result is intended to be published as a standard common to ISO and IEC, Standards and manuals. iv @ ISO 2004 - All rights reserved INTERNATIONAL STANDARD ISO 14617-14:2004(E) Graphical symbols for diagrams Part 14: Devices for transport and handling of material 1 Scope This part of IsO 14617 specifies graphical symbols in diagrams for components and devices for material transport and handling. ISO81714-1. graphical symbols used in diagrams, rules for the presentation and application of these symbols, and examples of their use and application, see IsO 14617-1. 2 Normative r