ISO INTERNATIONAL STANDARD 14518 First edition 2005-02-01 Cranes Requirements for test loads d'essai Reference number ISO 14518:2005(E) ISO @ ISO 2005 Copyright International Organization for Standardization Not for Resale ISO 14518:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56· CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CyghenatalganizatioSdadizatio @ISO2005-All rightsreserved No reproduction or networking permited without license from IHS Not for Resale ISO 14518:2005(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. isO shall not be held responsible for identifying any or all such patent rights. CoyghtIntemanalganizatadardizatoghtrerved ili tin r nenworking pemite without icense from Hs Not fr Resale Nreroductioneworkingemitedwithout licenefrmH Not for Resale ISO 14518:2005(E) INTERNATIONAL STANDARD Cranes Requirements for test loads 1 Scope This International Standard establishes methods for composition and measurement of test loads; procedures for the application of test loads during the testing of cranes. This International Standard was developed in addition to IsO 4310 and covers the types of cranes described in ISO 4306-1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISsO 4306-1, Cranes — Vocabulary — Part 1: General ISO 4310, Cranes — Test code and procedures IsO 9373, Cranes and related equipment Accuracy requirements for measuring parameters during testing 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 test load load designed for crane testing, which may consist of one or several components 3.2 direct method of measuring the mass of a test load determining the mass of a test load by weighing 3.3 combined method of measuring the mass of a test load determining the mass of a test load by calculating the sum of the masses of its components as determined by the direct method and/or calculation 3.4 application of test load action whereby the mass of a test load is transferred to the structure of the c