ISO INTERNATIONAL STANDARD 14231 First edition 2000-06-01 Thermal spraying Acceptance inspection of thermal spraying equipment Projection thermique - Controle d'acceptation du material de projection thermique Reference number ISO 14231:2000(E) ISO @ ISO 2000 by IHS under lic ted without license from IHS Not for Resale ISO 14231:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event ?ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2000 - All rights reserved ermittedwithoutlicense from IHS Not for Resale ISO 14231:2000(E) Contents Page Foreword. 1 Scope 2 Normative references .. 3 Purpose.... 4 Conditions for acceptance inspection 5 Designation......... 6 Principles of acceptance inspection . 7 Acceptanceinspectionprocedure.... 8 Validity of inspection reports and re-tests... 8 Annex C (informative) Inspection report for flame spraying equipment using wire, rod or cord.... ili T by IHS under lic se from IHS Not for Resale ISO 14231:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. patent rights. IsO shall not be held responsible for identifying any or all such patent rights International Standard ISO 14231 was prepared by Technical Committee ISO/TC 107, Metallic and other inorganic coatings. ional Organization for Standardization ISO2000-All rightsreserved INTERNATIONAL STANDARD ISO 14231:2000(E) Thermal spraying Acceptance inspection of thermal spraying equipment Scope including plasma, arc and flame spraying plants that produce high-quality sprayed coatings. 2 Normative reference The following normative document contains provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the normative document indicated below. For undated references, the latest edition of the normative document applies. Members of ISO and IEC maintain registers of currentlyvalidInternationalStandards. 3 Purpose The purpose of acceptance inspection of spraying equipment is to provide proof that the equipment is suitable for producing thermally sprayed coatings of uniform quality by satisfying the requirement of this International Standard, as part of the total quality assurance programme. This International Standard is also in