ISO INTERNATIONAL STANDARD 14096-1 First edition 2005-06-15 Non-destructive testing Qualification of radiographic film digitisation systems Part 1: Definitions, quantitative measurements of image quality parameters, standard reference film and qualitative control Essais non destructifs - Qualification des systemes de numérisation desfilmsradiographiques Partie 1: Definitions, mesures quantitatives des parametres de qualite d'image, film de réference normalisé et controle qualitatif Reference number ISO 14096-1:2005(E) @ ISO 2005 Copyright International Organization for Standardization Not for Resale ISO 14096-1:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below ?ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2005-All rightsreserved nitted without licensefromIHS Not for Resale ISO 14096-1:2005(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 14096-1 was prepared by the European Committee for Standardization (CEN) (as EN 14096-1:2003) and testing, Subcommittee SC 5, Radiation methods ISO/TC, in parallel with its approval by the ISO member bodies radiographic film digitisation systems: qualitative control Part 2: Minimum requirements ili ISO 14096-1:2005(E) EN 14096-1:2003 (E) Contents Page Foreword Introduction 1 Scope... 2 Normative references . ...5 3 Terms and definitions.. ..5 4 Evaluation procedures .. 5 Standard reference film... 12 6 Qualitative control and long term stability of the digitisation system .. ..14 2 Copyrigh International Organization for Standardization Iso2005-All rights reserved Reproduced by IHS unde ed without license from IHS Not for Resale IS0 14096-1:2005(E) EN 14096-1:2003 (E) Foreword This document (EN 14096-1:2003) has been prepared by Technical Committee CEN/TC 138, "Non-destructive testing", the secretariat of which is held by AFNOR. This European