ISO INTERNATIONAL STANDARD 13982-2 First edition 2004-11-15 Protective clothing for use against solid particulates - Part 2: Test method of determination of inward leakage of aerosols of fine particles into suits Vetements de protection a utiliser contre les particules solides - Partie 2: Methode d'essai pour la détermination de la fuite vers I'interieur d'aérosols de fines particules dans des combinaisons Reference number ISO 13982-2:2004(E) TSO @ISO2004 ISO 13982-2:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ? ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, Iso's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii ISo2004-All rights reserved ISO 13982-2:2004(E) Contents Page Foreword. .iv 1 Scope. 2 Normative references . 3 Terms, definitions, symbols and abbreviated terms.. 4 Principle. 5 Apparatus. 6 Testprocedure 7 Calculation of test results 8 Test report... Iso2004-All rights reserved ii ISO 13982-2:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 13982-2 was prepared by the European Committee for Standardization (CEN) Technical Committee Technical Committee ISO/TC 94, Personal safety— Protective clothing and equipment, Subcommittee SC 13, (Vienna Agreement), Iso 13982 consists of the following parts, under the general title Protective clothing for use against solid particulates: Part 1: Performance requirements for chemical protective clothing providing protection to the full body against airborne solid particulates (type 5 clothing) Part 2: Test method of determination of inward leakage of aerosols of fine particles into suits iv @ ISO 2004 - All rights reserved INTERNATIONAL STANDARD ISO 13982-2:2004(E) Protective clothing for use against solid particulates - Part 2: Test method of determination of inward leakage of aerosols of fine particles into suits 1 Scope This part of isO 13982 specifies a test method to determine the barrier efficiency of chemical protective clothing against aerosols of dry, fine dusts. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/TR 11610,