ISO INTERNATIONAL STANDARD 13765-6 First edition 2004-06-01 Refractory mortars - Part 6: Determination of moisture content of ready-mixed mortars Mortiers réfractaires- Partie 6: Détermination de I'humidite des mortiers prets a I'emploi Reference number ISO 13765-6:2004(E) ISO @ ISO 2004 CopyrightIntenationalOrganizationforStandardization No reproductin or networking pemited without license from IHs Not for Resale ISO 13765-6:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56· CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland CopyrightenatinalrganizationfrStandardizatin @ISO2004-All rightsreserved No reproduction or networking permited without license from IHS Not for Resale ISO13765-6:2004(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. isO shall not be held responsible for identifying any or all such patent rights. ISO 13765-6was prepared by Technical Committee ISO/TC 33, Refractories. Part 1: Determination of consistency using the penetrating cone method - Part 2: Determination of consistency using the reciprocating flow table method Part 3:Determination of joint stability Part 4: Determination of flexural bonding strength Part 5: Determination of grain size distribution (sieve analysis) -Part 6: Determination of moisture content of ready-mixed mortars CoyghtIntemanalOganizatandardizatoghtrerved ili eprductinrnetorkingpemitedwithout licensefromH Not fr Resale Nreroductioneworkingemitedwithout licenefrmH Not for Resale ISO 13765-6:2004(E) INTERNATIONAL STANDARD Refractory mortars - Part 6: Determination of moisture content of ready-mixed mortars 1 Scope This part of IsO 13765 describes a method for determining the moisture content of ready-mixed refractory mortars. 2 Normative references references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO 8656-1, Refractory products - Sampling of raw materials and unshaped products - Part 1: Sampling scheme 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 moisture content loss in mass of a sample dried at 110 °C, expressed as a percentage of the original mass of the sample 4Principle 5 Apparatus 5.1 Balance, capable of weighing to th