ISO INTERNATIONAL STANDARD 13473-3 First edition 2002-11-01 Characterization of pavement texture by use of surface profiles - Part 3: Specification and classification of profilometers Caractérisation de la texture d'un revetement de chaussée a partir de relevésdeprofilsdelasurface Partie 3: Specification et classification des appareils de mesure de profil Reference number ISO 13473-3:2002(E) @ ISO 2002 CopyrightInternational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 13473-3:2002(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland CyationalganzainStandardizatio @ ISO 2002 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 13473-3:2002(E) Contents Page Scope 1 2 Normative reference 1 3Terms and definitions General classes of profilometers for texture measurement 1 Types of measurements 3 Specific performance requirements 3 Calibration 9 Reporting of specifications 10 Annex A Calibration surfaces 11 Bibliography. 12 CopyrightInteratinal organization for Standagdizationuserved ili No reproduction or networking permitted without license from IHS Not for Resale ISO 13473-3:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of ISO 13473 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 13473-3 was prepared by Technical Committee ISO/TC 43, Acoustics, Subcommittee SC 1, Noise. ISO 13473 consists of the following parts, under the general title Characterization of pavement texture by use of surface profiles: Part 1: Determination of Mean Profile Depth Part 2: Terminology and basic requirements related to pavement texture profile analysis Part 3: Specification and classification of profilometers Annex A of this part of ISO 13473 is for information only. Copyright International Organization for Standardization @ ISO 2002 - All rights reserved Not fr Resale ISO13473-3:2002(E) Introduction 60's and have recently also been applied to general pavement surveys. Although most of the designs have been different. This part of iSO 13473 is an attempt to facilitate the comparison of different profilometers and to specify CopyrightInternational Organization for Standadizationserved V No reproduction or networking permitted