ISO INTERNATIONAL STANDARD 13433 First edition 2006-08-01 Geosynthetics Dynamic perforation test (cone drop test) Géosynthétiques Essai de perforation dynamique (essai par chute d'un cone) Reference number ISO 13433:2006(E) @ ISO 2006 IHSunder Not for Resale ISO 13433:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In ?ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2006 - All rights reserved Not for Resale ISO 13433:2006(E) Contents Page Foreword. iv 1 Scope 2 Normative references 3 Terms and definitions.. 4 Principle. 5 Apparatus 6 Specimens.. 6.1 Sampling... 6.2 Number and dimension of specimens.. 7 Conditioning.. 8 Procedure. 6 Calculation 10 Test report Copyrght International Organizaionfstadardizalonghtsreserved ii IHS unde from IHS Not for Resale ISO 13433:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 13433 was prepared by the European Committee for Standardization (CEN) Technical Committee CEN/TC 189, Geosynthetics in collaboration with Technical Committee ISO/TC 221, Geosynthetics, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement) @ ISo 2006-Allrights reserved tional Organizationfor Standardization INTERNATIONAL STANDARD ISO 13433:2006(E) Geosynthetics Dynamic perforation test (cone drop test) 1 Scope This International Standard specifies a method to determine the resistance of geosynthetics to penetration by a steel cone dropped from a fixed height. dropped on its surface. The method is generally applicable to geosynthetics. However, the validity of this test for some types of products should be considered carefully, as the test principle may not be applicable Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the cited edition applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso 554, Standard atmospheres for conditioning and/or testing Specifications ISO 9862, Geosynthetics — -Sampling and preparation of test specimens 3Term