ISO INTERNATIONAL STANDARD 13295 Second edition 2007-07-01 Dentistry Mandrels for rotary instruments Art dentaire Mandrins pour instruments rotatifs Reference number ISO 13295:2007(E) @ISO2007 by IHS under lic Not for Resale ISO 13295:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTED DOCUMENT @ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISo 2007 - All rights reserved I without license from IHS Not for Resale ISO 13295:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 13295 was prepared by Technical Committee ISO/TC 106, Dentistry, Subcommittee SC 4, Dental instruments. ii ISO 13295:2007(E) Introduction Mandrels are used for the support of rotary instruments. To achieve a general application, independent of the type of instrument, the standardization of mandrels is desirable. This will ease the usage of rotary instruments in dentistry. @ ISO 2007 -All rights reserved by IHS unde Not for Resale INTERNATIONAL STANDARD ISO 13295:2007(E) Dentistry Mandrels for rotary instruments Scope This International Standard specifies the requirements, the packaging and marking characteristics for mandrels suitable for discs and polishers used in dentistry. number for the identification of dental rotary instruments of all types. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. Iso 1797-1, Dental rotary instruments Shanks Part 1: Shanks made of metals ISO 1942, Dentistry- Vocabulary ISO 6360 (all parts), Dentistry — Number coding system for rotary instruments ISO 6892, Metallic materials — Tensile testing - - Method of testing at ambient temperature IsO 8325:2004, Dentistry- Test methods for rotary instruments 3 Terms and definitions For the purposes of this document, the term