ISO INTERNATIONAL STANDARD 12615 First edition 2004-12-01 Bibliographic references and source identifiers for terminology work Reférences bibliographiques et indicatifs de source pour les travaux terminologiques Reference number ISO 12615:2004(E) @ ISO 2004 ISO 12615:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ? ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2004 - All rights reserved ISO 12615:2004(E) Contents Page Foreword. Introductiol 1 Scope. 2 Normative references 3 Terms, definitions and abbreviations .. 3.1 Terms and definitions.. 3.2 Abbreviations 4 Forms of publications. 5 Use of bibliographic references and source identifiers in terminology work 5.1 General.. 5.2 Bibliographic references. 5.3 Source references. 6 Bibliographic references 6.1 General. 6.2 Documenttypes 6.3 Specification details 7 Source identifiers 7.1 General characteristics 7.2 System of source identifiers 7.3 Source identifiers fordifferent document types 10 8 Exchange of bibliographic references and source identifiers 12 8.1 Exchange of terminological data.. 12 8.2 Other exchanges ... 12 9 Experts' registers 13 10 Lists of bibliographic references ... .13 Annex A (informative) Examples of bibliographic references based on Iso 690 and Iso 690-2... Annex B (informative) Source identifiers for documents lacking an ISBN or ISSN . ..21 Annex C (informative) Representation of bibliographic references in an XML model for transfer or otherpurposes .24 Bibliography ... 26 alion'ghts reserved ii ISO 12615:2004(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen non-governmental, in liaison with iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 12615 was prepared by Technical Committee ISO/TC 37, Terminology and other language resources, Subcommittee Sc 2, Terminology and lexicography. @ Iso 2004 - All rights reserved ISO 12615:2004(E) Introduction bibliographic description and coding. A number of documentation standards deal with closely related