ISO INTERNATIONAL STANDARD 11698-2 First edition 2000-08-01 Micrographics Methods of measuring image quality produced by aperture card scanners Part 2: Quality criteria and control Micrographie - Méthodes de mesurage de la qualité de I'image produite par les numériseurs de cartes a fenetre - Partie 2: Criteres et controlede qualite Reference number E ISO 11698-2:2000(E) ISO @ ISO 2000 HS under ted without license from IHS Not for Resale ISO 11698-2:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2000 - All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 11698-2:2000(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iSc committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 11698 may be the subject of patentrights.ISOshall notbeheldresponsibleforidentifyinganyorallsuchpatentrights. International Standard ISO 11698-2 was prepared by Technical Committee ISO/TC 171, Document imaging applications, Subcommittee SC 1, Quality. IsO 11698 consists of the following parts, under the general title Micrographics — Methods of measuring image Part 1: Characteristics of the test images Part2:Quality criteriaand control Annexes A and B of this part of ISO 11698 are for information only. ii ISO 11698-2:2000(E) Introduction and electronic information systems is of great achieved by a scanner. @ISO 2000 -All rights reserved setworkingpemittedwithoutlicensefromHS Not for Resale INTERNATIONAL STANDARD ISO 11698-2:2000(E) Micrographics Methods of measuring image quality produced by aperture card scanners - Part 2: Quality criteria and control Scope This part of IsO 11698 specifies methods for using the test images specified in IsO 11698-1 to check the quality oi images produced by aperture card scanners. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of isO 11698. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part of isO 11698 are encouraged to investigate the possibility of applying the most recent editions of the no