ISO INTERNATIONAL STANDARD 11698-1 First edition 2000-08-01 Micrographics Methods of measuring image quality produced by aperture card scanners Part 1: Characteristics of the test images Micrographie - Methodes de mesurage de la qualite de Iimage produite par les numerisateurs de cartes a fenetre Partie1:Caracteristiques des images d'essai Reference number ISO 11698-1:2000(E) ISO @ ISO 2000 HS unde Not for Resale ISO 11698-1:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademarkofAdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland Iso2000-All rightsreserved itted without license from IHS Not for Resale ISO 11698-1:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of isO 11698 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. applications, Subcommittee SC 1, Quality. ISO 11698 consists of the following parts, under the general title Micrographics - Methods of measuring image qualityproduced byaperturecard scanners: Part 1:Characteristics of thetest images -Part 2: Quality criteria and control Annex A of this part of ISO 11698 is for information only. nafionai Organization for StandardizalionServed ili ISO 11698-1:2000(E) Introduction importance. This International Standard describes a series of test aperture card microimages, which can be used to @ ISO 2000 - All rights reserved working pemited without license from IHS Not for Resale INTERNATIONAL STANDARD ISO 11698-1:2000(E) Micrographics Methods of measuring image quality produced by aperture card scanners - Part 1: Characteristics of the test images Scope This part of Iso 11698 specifies the characteristics of the test images used for evaluating or checking the quality of electronic images generated by aperture card scanners. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of isO 11698. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part of IsO 11698 are encouraged to investigate the references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. IsO 3272-1:1983, Microfilming of technical drawings and other drawing office documents — Part 1: Operatin