ISO INTERNATIONAL STANDARD 11555-1 First edition 2003-07-01 Road vehicles Stabilizing devices for caravans and light trailers - Part 1: Integrated stabilizers Vehicules routiers Dispositifs stabilisateurs pour les caravanes et les remorques légeres- Partie 1: Stabilisateurs intégrés Reference number ISO 11555-1:2003(E) @ ISO 2003 Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO11555-1:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the @ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56· CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO2003-All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 11555-1:2003(E) Contents Page 1 Scope 2 Normative references 3 Terms and definitions . 4 Design requirements . 1 5 Testing on the test bench 5 6 Instructions for fitting and use 6 7 Marking 9 Bibliography . CopyrightInternatinal Organizatin forstandardization'ghts reserved ili No reproduction or networking permitted without license from IHS Not for Resale ISO 11555-1:2003(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies (isO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 11555-1 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 4, Caravans and light trailers. ISO 11555 consists of the following parts, under the general title Road vehicles - Stabilizing devices for caravans and light trailers: Part 1: Integrated stabilizers Blade stabilizers will be the subject of a future part 2. ationalOrganizationforStandardizatior @ ISO 2003 - All rights reserved Not fr Resale ISO 11555-1:2003(E) Introduction permitted if the coupling is approved by the manufacturer for use with such devices. Conformity with this part of IsO 11555 will ensure that, when in use, a stabilizing device will not adversely affect the permitted loading and operation of tow bar, coupling or braking devices. eiaaardizaighs reved V Nreroductionneworkingemitedwithout licenefrmH Not for Resale Copyrghtlntenational Organizationfor Standardization Nreroductionneworkingemitedwithout licenefrmH Not for Resale INTERNATIONALSTANDARD ISO11555-1:2003(E) Road vehicles Stabilizing devices for caravans and light trailers - Part 1: Integrated stabilize