ISO INTERNATIONAL STANDARD 115 First edition 2003-11-01 Unalloyed aluminium ingots for remelting Classification and composition Aluminium non allie en lingots pour refusion-Classification et composition Reference number ISO 115:2003(E) ISO @ ISO 2003 ISO 115:2003(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the @ISO.2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2003 - All rinhts reserved ISO 115:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. Unalloyed (refined) aluminium ingots. This first edition cancels and replaces ISO Recommendation ISO/R 115:1968. ISO 115:2003(E) INTERNATIONAL STANDARD Unalloyed aluminium ingots for remelting Classification and composition 1 Scope This International Standard defines the requirements for grades of unalloyed aluminium ingots intended for are produced, their properties and the marks by which they are identified. 2 Order The order, in the form agreed upon between supplier and purchaser, shall contain the following information: a) designation of the unalloyed aluminium in accordance with this International Standard or the customer code after agreement between supplier and purchaser; b) specification of the form of the products, including mass and dimensions of individual ingot and bundles; c) quantity: mass, in tonnes (quantity tolerances if required); d) any requirements for certificates of conformity, test and/or analysis reports or inspection certificates; e) any additional requirements agreed between supplier and purchaser. the order between supplier and purchaser, then these special requirements shall apply. 3Requirements 3.1 Production and manufacturing processes Unless otherwise specified on the order, the production and manufacturing processes shall be left to the discretion of the manufacturer. Unless otherwise specified on the order, no obligation shall be placed on the manufacturer to use the same processes for subsequent and similar orders. 3.2Quality control The supplier shall be responsible for carrying out all inspection and tests required by this International Standard the supplier's works, the purchaser shall stipulate this at the time of placing the order. 3.3 Chemical composition Each grade of unalloyed aluminium, including refined aluminium, with a specified minimum aluminium content shall be in accordance with the designations and chemical composition given in Table 1. Each grade of unalloyed aluminium without a specified minimum aluminium content shall be in accordance with the designations and chemical compositions given in Table 2. 'nht