ISO INTERNATIONAL STANDARD 11192 First edition 2005-11-01 Small craft Graphical symbols Petits navires - Symboles graphiques Reference number ISO 11192:2005(E) @ ISO 2005 ISO11192:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In ISO2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2005 - All rights reserved ISO 11192:2005(E) Contents Page Foreword. iv 1 Scope 2 Normative references 3 Terms and definitions 4 Use of graphical symbols . 5 Contents 6 Symbol colours < Media. 8 Conditions 9 Boat components. 6 10 Marine engine components . 11 Boat operation.. 9 12 Engine operation. 10 13 Engine operation (fuel)... 10 14 Engine operation (charge air).. 1 15 Engine operation (exhaust gas) .. 12 16 Engine operation (liquid coolant). .13 17 Engine operation (engine lubricating oil). 13 18 Engine operation (transmission lubricating oil) 14 19 Warning, caution, malfunction 15 20 Miscellaneous 16 Bibliography 17 alion'ghts reserved ili ISO 11192:2005(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO:11192 was prepared by Technical Committee ISO/TC 188, Small craft. @ ISo 2005 - All rights reserved INTERNATIONAL STANDARD ISO11192:2005(E) Small craft Graphical symbols Scope 1 This International Standard specifies graphical symbols for operator controls, gauges, tell-tales, indicators instructions and warnings against risks in small craft and for engines and other equipment intended to be used for small craft of up to 24 m length of hull. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. Iso 3864-1:2002, Graphical symbols - Safety colours and safety signs — Part 1: Design principles for safety signs in workplaces and public areas Iso 7000:2004, Graphical symbols for use on equipment Index and synopsis Iso 7010:2003, Graphical symbols — Safety colours and safety signs - Safety signs used in work